Chauvet Derby X Instrukcja Użytkownika

3000 N 29th Ct, Hollywood, FL 33020 U.S.A. (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.com Derby X™ Snapshot OK

4. OPERATING INSTRUCTIONS Operation Stand-Alone Mode (Sound-Active): This mode allows a single unit to run to the beat of the music, or the unit will

DMX Channel Values Channel Value Function 1 000 Ù 010 011 Ù 045 046 Ù 080 081 Ù 115 116 Ù 150 151 Ù 185 186 Ù 220 221 Ù 255 Cluster ControlNo Functio

SETTING THE STARTING ADDRESS This DMX mode enables the use of a universal DMX controller device. Each fixture requires a "start address" fro

DMX QUICK REFERENCE CHART DMX Address Quick Reference Chart Dip Switch Position DMX DIP SWITCH SET #9 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 0=OFF #8 0 0 0

Blow-out Diagram 3 6 Description PartNumber1 MasterPCB P172‐DERBYX2 ElectronicTransformer P140‐DERBYX3 Casecover P111‐DER

General Troubleshooting Symptom(s) Possible Solution(s) 1 or more LED’s are not illuminating Clean the fixture regularly to avoid any such failure. T

Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929

General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing f

Notes ________________________________________________________________________________________________________________________________________________

Technical Specifications WEIGHT & DIMENSIONS Length...

TABLE OF CONTENTS 1. Before You Begin ... 3 What

3000 N 29 Ct, Hollywood, FL 33020 U.S.A. (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.com thDerby X™ User Manual 20 7/

1. BEFORE YOU BEGIN What is included ¾ 1 x Derby X™ ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a f

Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of t

2. INTRODUCTION Features • 8-channel DMX-512 LED derby effect • Blackout/static/strobe • Individual control of red, green and blue LEDs within each cl

3. SETUP Fuse Replacement Disconnect the power cord before replacing a fuse and always replace with the same type fuse. The fuse is located inside th

CABLE CONNECTORS Cabling must have a male XLR connector on one end and a female XLR connector on the other end. COMMONDMX+DMX-INPUT OUTPUT1 3 2 1Term

Master/Slave Fixture Linking 1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.

Stacking The Derby X™ may be “stacked” by using multiple fixtures and the optional bracket (XBRACKET). This bracket may be ordered from CHAUVET. Th