Chauvet Vue III Instrukcja Użytkownika

Chauvet, 3000 N 29th Ct, Hollywood, FL 33020 U.S.A. (800) 762-1084 – (954) 929-1115 FAX (954) 929-5560 www.chauvetlighting.com Vue™ II Snap

4. OPERATING INSTRUCTIONS Operation Stand-Alone Mode (Sound-Active, Auto Mode, Strobe Mode, All On): This mode allows a single unit to run to the beat

DMX Mode This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with DMX, please read the DMX Primer on pag

SETTING THE STARTING ADDRESS This DMX mode enables the use of a universal DMX controller device. Each fixture requires a "start address" fro

DMX QUICK REFERENCE CHART DMX Address Quick Reference Chart Dip Switch Position DMX DIP SWITCH SET #9 0 0 0 0 0 0 0 0 1 1 1 1 1 1 1 1 0=OFF #8 0 0 0

General Troubleshooting Applies to Symptom Solution(s) Lights Foggers & Snow Controllers Dimmers& Chaser Auto shut off Check fan thermal swit

Technical Support Address: Service Dept. 3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.) Support (Email): [email protected] Telephone: (954) 929-1

Returns Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. Package must be clearly labeled

TABLE OF CONTENTS 1. BEFORE YOU BEGIN...

1. BEFORE YOU BEGIN What is included ¾ 1 x Vue™ II ¾ Power Cord ¾ Warranty Card ¾ User Manual Unpacking Instructions Immediately upon receiving a fi

Safety Instructions Please read these instructions carefully, which includes important information about the installation, usage and maintenance of

2. INTRODUCTION Features • 6-channel DMX-512 LED moon flower • Blackout/static/dimmer/strobe • Individual control of red, green and blue LEDs • Bui

Product Overview Tilt Adjustment KnobHanging Bracket Power LED MicrophoneSignal/Sound Indicator LED Power Output Connector D

3. SETUP Disconnect the power cord before replacing a fuse and always replace with the same type fuse. Fuse Replacement The fuse is located inside t

CABLE CONNECTORS This drawing provides a general illustration of the DMX Input/Output panel of a lighting fixture. U X Controller niversal DMContinue

Often, the setup for Master-Slave and Standalone operation requires at the first fixture in the chain be itialized for this purpose via either ttings