Chauvet Tiger DMX 60 Instrukcja Operatora Pobierz pdf (Strona 131)

7. Chases - Page 163

Pearl 2008 Manual - 16th July 2007

7.3.3 Editing a chase using Unfold

The Pearl has a powerful chase editing

system. The Unfold button places each

step of a chase on one of the playback

faders as if each step was a memory,

allowing you to turn on and edit each

step individually.

Tiger: If a chase has more than 10

steps, the Tiger Wing must be

connected to access steps 11-

15 on each page.

The display (right) shows the step

number, step legend, whether the

step is Simple or Complex, and

whether links are turned off (-) or on

(down arrow).

1> Press Unfold (one of the blue

command buttons), then the

Swop button of the chase to be

edited

2> The first 15 steps of the chase are loaded into playback faders 1-

15. The display shows details about the steps.

3> Raise a playback fader to output the contents of that step (fade

times will operate as programmed)

4> Various Unfold options are available, the details are below.

5> Press Unfold again to get out of unfold mode.

• To edit the contents of a step: Press Clear to empty the

programmer, raise the fader to output the step, make the

changes, press A [Record], then the Swop button (1-15) for the

step number.

• To change the times for the step, press B [Edit Times], then the

flash button for the step, then set the times (see Timing on the

following page)

• To Insert a new step, set up the lights for the new step, press C

[Insert], then the Swop button where you want to insert the new

step. The new step will be allocated to the button you press with a

step number half way between the steps either side, and all other

steps will be shifted along one. (You cannot use the blue Insert

button in Unfold mode).

• To Delete a step, press D [Delete] then the Swop button for the

step you want to delete, followed by Enter.

• You can copy a step by holding the Flash button of the step to

copy, then pressing the Swop button of the step to copy it to.

• You can renumber the chase to whole numbers by pressing C

[Insert], A [Renumber], then Enter to confirm.

• If the chase has more than 15 steps, you can swap to the next 15

steps using softkey F, or the previous 15 steps using softkey E.

• G [Shape Generator] allows you to insert and edit shapes in the

chase steps.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 205 206

Komentarze do niniejszej Instrukcji

Brak uwag

Chauvet Tiger DMX 60 Instrukcja Operatora Strona 131

Komentarze do niniejszej Instrukcji