Chauvet Tiger DMX 60 Instrukcja Operatora Pobierz pdf (Strona 94)

Page 126 - 3. Controlling dimmers and fixtures

Pearl 2008 Manual - 16th July 2007

3.1.2 Changing attributes of the selected fixtures

“Attributes” are the functions of the fixture, like pan, tilt, colour,

dimmer, etc. You select which attributes you want to modify using the

buttons on the right edge of the console

and set values using the wheels at the

bottom of the Pearl. The attributes

available depend on the fixture type.

Dimmer channels only have a dimmer

attribute. The Pearl can control up to 40

attributes per fixture.

Each attribute button controls two

attributes, one on the left wheel and

one on the right wheel.

1> Press the button for the attribute

to be changed

2> Turn the wheels to set the

attribute. The display above the

wheels shows which attributes are being controlled.

3> Repeat from 1 to change other attributes of the selected fixtures.

Some other things to know about attributes:

• The Attribute buttons let you select the first 20 attributes. Another

20 attributes are available by pressing the “Attribute Banks 11-20”

button, to cater for the weird and wonderful DMX fixtures of the

future. The light on the button stays on when you are using the

top 20 attributes.

• If the display above the wheels does not show the attribute when

you press the button, that attribute is not available on the

selected fixtures.

• You can directly control the intensity of the fixture/dimmer using

the fader of the handle.

• You can view the available attributes by pressing the View button

then B [Fixture Attributes]. The display shows a list of available

attributes for the fixture you’ve selected.

• The wheels operate in an “acceleration” mode. If you spin the

wheel fast, the fixture changes in larger steps. If you move the

wheel slowly, the fixture moves in its smallest increment. (This

replaces the 16-bit mode found on older Pearl software). You can

change the acceleration response of the wheels by holding down

AVO and pressing 2 (see page

197 for details). You may want a

different response for very fine adjustments, or to suit your wheel

spinning style.

• Holding down AVO while turning a wheel puts the wheel into

“hyper-drive” mode where one complete revolution takes the

attribute from 0 to 100%.

• The display above the wheels either shows the output value

(percentage and raw DMX value), or it can show Intelligent

Attribute Display (for a colour wheel, the display would show

“Open”, “Red”, “Orange” and so on as you turn the wheel). Hold

down AVO and press 1 to enable or disable Intelligent Attribute

Attribute select buttons

Control wheels

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 205 206

Komentarze do niniejszej Instrukcji

Brak uwag

Chauvet Tiger DMX 60 Instrukcja Operatora Strona 94

Komentarze do niniejszej Instrukcji